Walli Dimmer

• Can be used for dimming:
  • 110/230V operated conventional incandescent and halogen,
  • 12V operated ELV halogen lamps and dimmable LED bulbs (with electronic transformers),
  • 12V operated MLV halogen lamps (with ferromagnetic transformers),
  • dimmable LED bulbs,
  • dimmable compact fluorescent CFL tube lamps,
  • supported dimmable light sources (power factor > 0.5) with minimal power of 5VA using FIBARO Bypass 2.
• Can be used for switching:
  • compact fluorescent CFL tube lamps with electronic ballast,
  • fluorescent tube lamps with electronic ballast,
  • LED bulbs (power factor > 0.7),
  • supported light sources (power factor > 0.5) with minimal power of 5VA using FIBARO Bypass 2.
• Uses different operating modes:
  • „Trailing edge” for resistive loads (R)
  • „Trailing edge” for resistive-capacitive loads (RC)
  • „Leading edge” for resistive-inductive loads (RL)
• Can be used with FIBARO Walli covers or other compatible (see “Parts compatibility”):
  • GIRA – System 55 (Standard 55, E2, Event, Event Clear),
  • Legrand – Céliane,
  • Schneider – Odace.
• Active power and energy consumption metering.
• Can be installed in two and three-wired configuration.
• Calibrates automatically to the connected light source.
• Supports Z-Wave network Security Modes: S0 with AES-128 encryption and S2 Authenticated with PRNG-based encryption.
• Works as a Z-Wave signal repeater (all non-battery operated devices within the network will act as repeaters to increase reliability of the network).
• May be used with all devices certified with the Z-Wave Plus certificate and should be compatible with such devices produced by other manufacturers.

Specifications

Power supply	110-230V~ 50/60 Hz
Compatible load types		Resistive loads Conventional incandescent and halogen light sources
		Resistive-capacitive loads Fluorescent tube lamp (compact / with electronic ballast), electronic transformer, LED
		Resistive-inductive loads Ferromagnetic transformers
Rated load current	0.22A-1.52A – resistive loads (incandescent and halogen) 0.22A-1.3A – resistive-capacitive loads (fluorescent tube lamp, electronic transformer, LED) 0.22A-1.3A – resistive-inductive loads (ferromagnetic transformers) 0.022A-0.22A – with Bypass 2: fluorescent tube lamp or LED
Active element	semiconductor electronic switch ε
Recommended external overcurrent protection	10A type B circuit breaker (EU) 13A type B circuit breaker (Sweden)
For installation in boxes	Ø = 60mm, depth ≥ 40mm
Recommended wires	cross-section area between 1.5-4.0mm2, stripped 12-12.5mm of insulation
Operating temperature	0–35°C
Ambient humidity	10–95% RH without condensation
Radio protocol	Z-Wave (500 series chip)
Radio frequency band	868.0–868.6MHz; 869.7–870.0MHz
Max. transmitting power	+6dBm
Range	up to 50m outdoors up to 40m indoors (depending on terrain and building structure)
Dimensions (Height x Width x Depth)	86 x 86 x 51 mm
Compliance with EU directives	RoHS 2011/65/EU RED 2014/53/EU